Initialising AdminBot

AdminBot have to know the SL group name you are going to use.

Sending SB_SETUP_SETGROUP command

You can set the group in two ways:

• By calling SB_SETUP_SETGROUP command (with the group name).

• By calling SB_SETUP_SETGROUPUUID command (with the group UUID).

llMessageLinked(LINK_SET, SB_SETUP_SETGROUP, "My group name", "SECURITY CODE");

OR

llMessageLinked(LINK_SET, SB_SETUP_SETGROUPUUID, "SECURITY CODE", "group-UUID");

(yes, the above examples are correct: you can pass the string value instead of key)

Security Code

To protect your group from abusive scripters, you have to pass the group security code while initializing - (read more about security code).

Determining Success

AdminBot will raise the event after SB_SETUP_SETGROUP or SB_SETUP_SETGROUPUUID:

• SB_SETUP_SUCCESS indicates that this group can be used now

• SB_SETUP_FAILED indicates that there were an error setting the group.
  See AdminBot Status Codes for details.